midiphy Wirescanner shell
Manufacturer: midiphy
Product ID: C-UTL-02
Shell case to hold the first-generation wirescanner PCB, including mounting hardware. Might have a few irregularities from 3D printing, but will protect your scanner PCB from scratches and short circuits on the rear.
Weight: 50 grams
15.37 €
incl. VAT, excl. shipping
Recommended products
These additional products may be of interest,
if you are browsing this product. If you are buying a midiphy essential kit, everything necessary
is included. If you are buying basic products, please check if any of these items may be helpful for your build.
Note
You can put your wirescanner shell in water for 24 hours - this will dissolve the PVA stabilizing material that was used for 3D printing. Or you could just remove the outer brim with a knife and keep the inner logo made from PVA intact! :)
Introduction Video